When I turn on my clothes washing machine (Maytag) the water does not come in the tub, how to repair it?

Sounds like the ';pressure system control';


If no water enters the washing machine, but the drum starts turning (as though washing normally) then you should stop the washing machine as there may be a fault in the pressure system that controls the levels of water. This fault can cause the timer to receive a false signal that water is already in the washing machine and the heater may be energized. This can damage the heater or burn the clothes inside. A blocked pressure chamber can trap air in the pressure tubing and leave the pressure switch on. If this happens, when you put the washing machine onto a wash program it doesn't take any water in and starts washing because it things there is water inside. This fault should also prevent the washing machine going into spin though too.


It is a complex repair...I would suggest calling a professional.When I turn on my clothes washing machine (Maytag) the water does not come in the tub, how to repair it?
If both hot and cold stopped running then I would assume the valve needs to be replaced.....providing the washer has power running to it.





If the water trickled in over a period of time...I would suggest removing the hoses from the back and cleaning the filter screens in the valves.





Good LuckWhen I turn on my clothes washing machine (Maytag) the water does not come in the tub, how to repair it?
your line may be cloged or turned off. try calling the company and resort to your manual to troubleshoot. also there are repair manuals you can buy or check out at the library
assuming you have a water supply turn the water off remove the hose and check that the sreen in the hose is not pluged this is very common in areas with hard water supply!!
Probably the pump that lets the water in is bad.